Sunwave Tech. SRC-1600 Manuel d'utilisateur télécharger pdf (Page 17)

Using preset codes

Manually setting preset codes

1. Find your device in the supplied list of preset

codes.

2. Press and hold

to enter setup.

3. Press

4. Find the digit code number

from the pre-programmed

code list.

5. Use the number buttons to

enter the four digit code.

(Refer to the pre-programmed

code list table.)After you enter

the last digit, a double beep

sounds, confirming the code

has been input. If the number isn’t in the code

data base, the SRC-1600 will beep three times

continuously. Please try another number.

6. Check you have entered the correct code by

pressing Volume +/–, Channel +/– or

7. If the code is correct, press

to confirm

and exit. If the code is not correct, repeat

step 4. See Checking the code number on

page 14

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Sunwave Tech. SRC-1600 Manuel d'utilisateur Page 17